How To Properly Measure

Video instruction

Step by step instructions with photos

Step 1

All measurements must be performed on a non-erect FULLY stretched penis.

Hold the end of the band marked “0” at the base of penis and press back until you hit your pelvic bone.

Step 2

Hold the tip of your non-erect penis and stretch it out as far as you comfortably can.

Step 3

Measure to the tip of the head. In this example the ruler measures 13.

Note: If your length is in between numbers (on the line), use the lower number (this is critical, do not round up… only round down).

Step 4

Fully pull or roll back the skin behind the head under the penis and apply lubricant to the area directly behind the head of your penis.

Step 5

Loop the band thru the opening so the letters are on the outside of the ring. Wrap the ruler around your exposed shaft until tight.

Pull the band tight so it is snug against your penis.

Step 6

Hold the flap and band with one hand, then use your other hand on the opposite side and pull your penis forward to a comfortable length. You will want to make sure that its tight enough so the Erektor™ will not slip off when lubricated. In this example the measurement is “D”.

Note: If your measurement is on the line between 2 letters, use the smaller letter.

How to measure with the silicone band

Looking for a medication-free, non-invasive, instant solution?

Click here to get started and Order your Erektor Today!

Instant results guaranteed!

Erektor™ is registered by